Great Plains YP625PD Operator Manual - Manual (Page 36)

32 YP625PD Table of Contents Index Great Plains Manufacturing, Inc.
401-754M Table of Contents Index 02/23/2011
Marker Operation (Option)
Before Operating Markers
• Make sure cylinders are properly bled. See “Marker
Maintenance (Option)” on page 82.
• This section presumes correct marker extension for
your pass spacing. If this has not been set, or needs to
be changed, see “Marker Extension” on page 111.
• Markers are equipped with an automatic sequence
valve that controls which side activates, as well as
marker deployment speed. Marker folding speed is
adjusted via set screws on the sequence valve body.
Excessive folding speed may damage markers. Set
speed prior to first field operations. See “Marker
Speed Adjustment” on page 111.
Marker Unfold (one side)
1. Move tractor hydraulic control (lever or switch) for the
marker circuit (typically to Extend). Hold until marker
is completely unfolded. Do not leave tractor control in
detent.
2. If the marker side operating is not the desired side,
let it unfold part way, and move the tractor’s circuit
control to Retract. When the marker is folded, move
the circuit control to Extend to activate the other side.
Both Sides Unfolded
With both markers in the upright/tilted positions:
1. Unfold either side, and when completely deployed:
2. Move lever/switch to Retract momentarily, and return
to Extend to deploy other side.
Row Marker Operation
To alternate which side is marked:
1. Move the tractor’s circuit control to Retract. Hold until
marker is folded.
2. Move the tractor’s circuit control to Extend. Hold until
the new side’s marker is fully unfolded.
3. Return tractor control to neutral/off.
Folding The Markers
If your planter has markers, fold them before performing
a lift operation.
1. Move the tractor’s circuit control to Retract. Hold until
marker is folded.
2. Tilt markers down for transport or storage.
Overhead, Crushing and Sharp Object Hazards:
Do not allow anyone to stand near or beyond the end of the
wings during marker operations. There is risk of serious injury
or death for anyone in the path of a marker. Marker arms are
heavy, are under tremendous hydraulic power, and may move
suddenly if the hydraulic system is damaged or needs bleeding.
Marker discs may be sharp.