Great Plains ADC2220 Operator Manual User Manual
Operator manual, Manufacturing, inc

Manufacturing, Inc.
© Copyright 2012
Printed 2012-10-17
167-073M
EN
ORIGINAL INSTRUCTIONS
Operator Manual
ADC2220
Air Drill Cart
Read the operator manual entirely. When you see this symbol, the
subsequent instructions and warnings are serious - follow without
exception. Your life and the lives of others depend on it!
Illustrations may show optional equipment not supplied with standard unit, may depict
an ADC1150 or ADC2350/B model where a topic is identical, and may depict any of
several air drill implements.
16263
Table of contents
Document Outline
- Operator Manual
- Table of Contents
- Important Safety Information
- Look for Safety Symbol
- Be Aware of Signal Words
- Prepare for Emergencies
- Be Familiar with Safety Decals
- Avoid High Pressure Fluids
- Use A Safety Chain
- Keep Riders Off Machinery
- Use Safety Lights and Devices
- Check for Overhead Lines
- Transport Machinery Safely
- Wear Protective Equipment
- Handle Chemicals Properly
- Confined Space
- Shutdown and Storage
- Practice Safe Maintenance
- Tire Safety
- Safety At All Times
- Safety Decals
- 818-055C Slow Moving Vehicle Reflector
- 838-266C Red Reflectors
- 838-265C Amber Reflectors
- 818-557C Danger: Cannot Read English
- 818-624C Danger: Hitch Crushing Hazard
- 818-627C Danger: Electrocution Hazard
- 818-633C Danger: Missing Guard Hazard
- 818-634C Danger: Rotating Auger
- 818-188C Warning: Excessive Speed
- 818-339C Warning: High Pressure Fluid Hazard
- 818-622C Warning: Overhead Auger Hazard
- 818-622C Warning: Overhead Auger Hazard
- 818-623C Warning: Pinch Point Hazard
- 818-628C Warning: Confined Space
- 818-632C Warning: Fan Hazard
- 818-630C Caution: General
- 818-635C Caution: Auger General
- 818-789C Caution: Tire Pressure
- 818-560C Safety: Notice to Owner
- Introduction
- Preparation and Setup
- Operating Instructions
- Loup II Monitor Operation
- Adjustments
- Seed Rate Charts
- Troubleshooting
- Maintenance and Lubrication
- Chain Maintenance
- Lubrication and Scheduled Maintenance
- Main Shaft Bearings
- Clutch Shaft Bearings
- Gearbox Jackshaft Bearings
- Gearbox Output Shaft Bearings
- Hopper Lid Pivot bar and Clamps
- Meter Box Door Clamps
- Auger Storage Clamp
- Auger Swing Arm: Mount Pivot
- Auger Swing Arm: Inner-to-Outer Pivot
- Auger Swing Arm: Outer Pivot
- Gearbox: Sump
- Hub Chain
- Driveshaft Output/Clutch Input Chain
- Clutch Output/Gearbox Input Chain
- Gearbox Output/Meter Input Chains
- Main Wheel Bearings
- Options
- Appendix A - Reference Information
- Appendix B - Initial Setup
- Appendix C - Vintage Carts
- Index