Great Plains PD8070 Operator Manual User Manual
Operator manual, Manufacturing, inc
Manufacturing, Inc.
© Copyright 2014
Printed 2014-07-23
401-479M
EN
ORIGINAL INSTRUCTIONS
Operator Manual
2007+ PD8070
PD8070 8-Row 70cm Pull-Type Planter
Read the operator manual entirely. When you see this symbol, the
subsequent instructions and warnings are serious - follow without
exception. Your life and the lives of others depend on it!
Illustrations may show optional equipment not supplied with standard unit or may
depict similar models where a topic is identical.
25414
Table of contents
Document Outline
- Operator Manual
- Table of Contents
- Important Safety Information
- Look for Safety Symbol
- Be Aware of Signal Words
- Prepare for Emergencies
- Be Familiar with Safety Decals
- Avoid High Pressure Fluids
- Wear Protective Equipment
- Handle Chemicals Properly
- Use A Safety Chain
- Keep Riders Off Machinery
- Use Safety Lights and Devices
- Transport Machinery Safely
- Shutdown and Storage
- Tire Safety
- Practice Safe Maintenance
- Safety At All Times
- Safety Decals
- Slow Moving Vehicle Reflector 818-055C
- Red Reflectors 838-266C
- Amber Reflectors 838-265C
- Daytime Reflectors 838-267C
- Warning: Transport Speed 818-188C
- Warning: High Pressure Fluid Hazard 818-339C
- Warning: Sharp Object (Option) 818-525C
- Warning: Moving Chain 838-363C
- Warning: Markers Overhead 838-367C
- Caution: Transport Locks 818-351C
- Caution: Read Operators Manual 818-587C
- Introduction
- Preparation and Setup
- Operating Instructions
- Adjustments
- Setting Material Rates
- Contact Drive Tension
- Marker Adjustments
- Row Implement Adjustments
- Troubleshooting
- Maintenance and Lubrication
- Maintenance
- Bleeding Hydraulics
- Meter Maintenance
- Finger Meter Maintenance
- Exchanging Finger Sets
- Remove Meter Cover
- Remove Adjustment Lever
- Remove Brush Block
- Remove Corn Finger Set
- Remove Insert “A”
- Install Insert “C”
- Install Brushless Block
- Install Sunflower Finger Set
- Set Finger Set Torque
- Re-Install Corn Finger Set
- Brush Meter Maintenance
- Seed Plate Maintenance
- Lubrication and Scheduled Maintenance
- Seed Lubricant
- Depth Gauge Wheel Arms
- Depth Gauge Wheel Module
- Markers
- Dry Fertilizer Outlet (Option)
- Frame-Mounted Coulter Hub
- Frame-Mounted Coulter Pivot
- Transport Wheel Bearings
- Rigid Row Cleaner Bearing (Option)
- Contact Drive Chains
- Reverser Chains
- Transmission Chains
- Meter Drive Chains
- Dry Fertilizer Jackshaft Drive Chain
- Dry Fertilizer Drive Chain
- Frame-Mounted Vantage II Coulters (Option)
- Marker Disk Hubs (Option)
- Options
- Appendix A - Reference Information
- Appendix B - Initial Setup
- Index