ClearOne MAXAttach IP - Manual (Page 7)

4 Technical Support: 800.283.5936
CHAPTER 2: GETTING STARTED
CONNECTING THE CONFERENCING PHONE
1. Connect the Connection cable from the Link Out jack on the base unit to the Link In jack on the conferencing pod
(Figure 2.1).
WARNING: DO NOT plug a laptop or PC into the Link Out jack on the base unit or conferencing pod -
severe electrical damage can occur if this is done.
2. Connect the base unit to the Ethernet jack using the Ethernet cable.
3. Connect the power cord to the base unit and plug it directly into an electrical outlet.
CONNECTING ADDITIONAL MAX IP PHONES
1. Connect the 12’ Connection cable to the Link Out jack on the first phone and to the Link In jack on the second
phone (Figure 2.2).
2. Continue linking up to two additional MAX IP phones in the same fashion. A total of four units may be connected at
a time.
Figure 2.1 - Connecting the MAX IP
Figure 2.2 - Connecting Additional Units
12' Connection cable
From Link Out
To Link In To Link In
To Link Out on Base Unit
25' Connection cable