ClearOne MAXAttach IP - Manual (Page 10)

Chapter 2: Getting Started 7
The following parameters are available for configuring the phone settings and phone-specific files.
Configuration: General Settings
See Web Portal Provisioning screen on page 15 for the login procedure and/or the Configuration: General Settings
screen on page 17 for configuring this setting via the Web Portal.
<
username> - The username for logging into the Web Portal.
Default value: admin
< password> - The password for logging into the Web Portal.
Default value: clearone
< helpline_num> - The number dialed when the help line speed dial is called.
Default Value: Not set
Allowable Characters: [0-9]
< allow_reboot_in_call> - Allow the phone to be rebooted if it’s currently in a call. This parameter is useful when
remote provisioning through the Web Portal interface. If a reboot command is issued remotely, it will not take immediate
effect if this parameter is set to 0.
Default Value: 0
Allowable Values:
0 - Wait until the call is completed before the phone is rebooted
1 - Reboot phone immediately
Configuration: User Preferences
See Configuration: User Preferences screen on page 18 for information on how to set these parameters through the
Web Portal.
<
alc_enable> - Automatic Level Control (ALC) Enable.
Default Value: 0
Allowable Range:
0 - Disable
1 - Enable
< agc_enable> - Automatic Gain Control (AGC) enable.
Default Value: 0
Allowable Range:
0 - Disable
1 - Enable
< mute_ringtone> - Mute Incoming Ringer for an incoming call.
Default Value: 0
Allowable Values:
0 - Disable Mute
1 - Enable Mute
» NOTE: If the ringer is disabled, the LED indicators on the pod(s) will still flash on an incoming call.
< ringtone> - The default Incoming Ringer Melody when the phone rings.
Default Value: 1
Range: 1-5