LaMotte TC-3000 Tri-Meter - Manual (Page 42)

* Warning: Reagents marked with an * are considered to be potential health hazards.
To view or print a Material Safety Data Sheet (MSDS) for these reagents see MSDS CD
or go to www.lamotte.com. To obtain a printed copy, contact LaMotte by e-mail,
phone or fax.
Note: For the most accurate results, samples over 6 ppm chlorine should be diluted
with chlorine demand free water and re-tested.
Note: The meter will remember the last scanned blank reading. It is not necessary to
scan a blank each time the test is performed. To use the previous blank reading,
instead of scanning a new one, scroll to Scan Sample and proceed. For the most
accurate results, the meter should be blanked before each test and the same tube with
tube positioning ring should be used for the blank and the reacted sample.
Total Chlorine
1. Press
ON to turn the meter on.
1 . 3
2. Press
*IOK to select Measure.
M a i n M e n u
* M e a s u r e
D a t a L o g g i n g
O p t i o n s
1 6 : 0 2 : 1 9 0 1 / 0 4 / 0 5
3. Scroll down and then press
*IOK
to select Chlorine.
M e a s u r e
T u r b i d i t y
C o l o r
* C h l o r i n e
1 6 : 0 2 : 1 9 0 1 / 0 4 / 0 5
4. Press
*IOK to select Test Total
Chlorine.
C h l o r i n e ( L )
T e s t F r e e
* T e s t T o t a l
1 6 : 0 2 : 1 9 0 1 / 0 4 / 0 5
42 ANALYSIS & CALIBRATION • CHLORINE