LaMotte TC-3000 Tri-Meter - Manual (Page 10)

OPTIONS & SET UP
FACTORY DEFAULT SETTINGS
Settings that have user options have been set at the factory to default settings.
The factory default settings are:
Turbidity Units
NTU
Turbidity Calibration formazin
Chlorine Units ppm
Chlorine Calibration Tablet
Averaging Disabled
Date Format MM/DD/YY
Language English
Auto Shutdown Disabled
RESET TO FACTORY DEFAULT SETTINGS
To return the meter to the factory settings, turn the meter off. Hold down
*IOK button.
Press
ON. Release both buttons. Press *IOK button to select the default settings.
Meter will turn off and the factory settings will be restored. Restoring the factory settings
will remove the user-level calibration but not the zeroing. To change the default
settings follow the instructions in the following sections.
TURBIDITY
The default units are NTU and the default calibration curve is formazin. To change the
settings:
Selecting Turbidity Units
1. Press
ON to turn the meter on.
1 . 3
2. Scroll down and then press
*IOK
to select Options.
M a i n M e n u
M e a s u r e
D a t a L o g g i n g
* O p t i o n s
1 6 : 0 2 : 1 9 0 1 / 0 4 / 0 5
10 OPTIONS & SETUP • TURBIDITY