Warranty – Powers 595 Series 11 Self-Operating Temperature Regulators - Type ST Stainless Trim User Manual

Page 16

USA: Phone: 1.800.669.5430 • Fax 1.847. 229 . 0526 • www.powerscontrols.com

Canada: Phone: 1.888.208.8927 • Fax 1

888

479

2887

•

www.powerscontrols.ca

IS-P-595ST 0815

6509040

Warranty

■

The Seller warrants that the equipment manufactured by it and covered by this order or contract is free from defects in material and workmanship and, without
charge, equipment found to be defective in material or workmanship will be repaired, or at Seller’s option replaced F.O.B. original point of shipment, if written
notice of failure is received by Seller within one (1) year after date of shipment (unless specifically noted elsewhere), provided said equipment has been properly
installed, operated in accordance with the Seller’s instructions, and provided such defects are not due to abuse or decomposition by chemical or galvanic action.
THIS EXPRESS WARRANTY IS IN LIEU OF AND EXCLUDES ALL OTHER WARRANTIES, GUARANTEES, OR REPRESENTATIONS, EXPRESS OF IMPLIED. THERE ARE
NO IMPLIED WARRANTIES OF MERCHANTABILITY OR OF FITNESS FOR A PARTICULAR PURPOSE. The Seller assumes no responsibility for repairs made on the
Seller’s equipment unless done by the Seller’s authorized personnel, or by written authority from the Seller. The Seller makes no guarantee with respect to material
not manufactured by it.

(Continued from page 9 )

• Constant high (too hot) or rising temperature

of the process ﬂ uid

1. DA (Heating Valve): A constantly high or rising temperature

may indicate the thermal system is leaking charge and/or
the valve has failed in a partially or fully open position. This
would allow a constant ﬂ ow of heating medium, which would
overheat the ﬂ uid which you are trying to control.

2. RA (Cooling Valve): A constantly high or rising temperature

may indicate the thermal system is leaking charge, and/or
the valve has failed in a partially or fully closed position. This
would slow or stop the ﬂ ow of cooling medium which would
overheat the ﬂ uid which you are trying to control.