Powers 900 Series Biltmore Series Pressure Balancing Mixing Valves - Thin Wall Mounting Kit - Manual

NOTE: Installation should be in accordance with accept-
ed plumbing practices. Flush all piping thoroughly before
installation.
KIT CONTENTS
QTY DESCRIPTION PART NO.
1 Thin Wall Mounting Bracket . . . . . . . . .900-118
TO INSTALL
1. Mount the thin wall mounting bracket before the wall is in
place.
2. If the wall is in place, cut rough-in dimensions as shown in
Figure 1.
3. Position the thin wall mounting bracket over the bonnet of
the Biltmore Series 900 Mixer, shown in Figure 2, as “First
Position.”
4. Rotate the bracket 30° counterclockwise, shown in Figure
2, as “Second Position.”
5. Installation of the valve trim should be completed accord-
ing to installation instruction furnished with the Biltmore
Series 900 Mixer.
INSTALLATION INSTRUCTIONS
BILTMORE Series 900 Valves
Thin Wall Mounting Kit #900-119 A Watts Industries Co.
Cut (2) 52 mm
[2-1/16 – 1/32]
Dia. holes
Cut (1) 106 mm
[4-3/16 – 1/32]
Dia. Hole
51 mm
[2.0 in.]
51 mm
[2.0 in.]
S
T
Cutout in wall
FIRST position (0 ° rotation)
Brackets to rest on
Hot & Cold Inlet Ports
in both positions
Series 900 valve
Wall line
COLD
INLET
HOT
INLET
Thin wall
mounting bracket
SECOND position (dotted
image) Rotate mounting
bracket 30
° counterclockwise
30 °
FIGURE 2
FIGURE 1
© Reprinted April 2001 Powers, a Watts Industries Co.
3400 Oakton Street, Skokie, IL 60076 Phone: 800.669.5430 • 847.673.6700 • Fax: 847.673.9044
www.powerscontrols.com
5435 North Service Road, Burlington, Ontario, L7L 5H7 Canada • Phone: 888.208.8927 • Fax: 888.882.1979 A Watts Industries Co.
Form II900-119
Form II900-119 0218 EDP# 6507710 Printed in U.S.A.