Powers 450-e420 HydroPanel II Shower System - Corner Mount - Manual

INSTRUCTIONS
A. HYDROPANEL CORNER-MOUNT INSTALLATION w/o
EXTENSION AND/OR OVERLAYS.
1. Mount Corner-mounting brackets to wall. To find
proper distance, measure distance “X” between
holes on upper and lower (B and C, See Figures 1
& 2) fittings of outlet pipe (for 900 valve, lower fitting
is sweated on tub-side of the body).
1a.Corner mounting bracket anchors provided by others.
2. Mount piping assembly to corner brackets, using
larger screws and nut for top portion, and smaller
screws and nuts for bottom. (For 900 valve, use only
large screws and nuts).
3. Replace straight end caps with corner end caps and
mount to shrouding (do this before mounting
shrouding to piping).
4. Attach shrouding to piping with screw at A & D
(See Figure 1).
5. Follow installation instructions in TI450-900 V1
beginning with TEST THE SYSTEM.
B. HYDROPANEL CORNER-MOUNT INSTALLATION
w/EXTENSIONS AND/OR OVERLAYS.
1. Follow steps 1 & 2 as outlined in “A”.
2. Mount corner-mounting brackets to wall. Use one
bracket for the Hydropanel extension, and the sec-
ond bracket if an overlay is needed. Measure the slot
distances to determine placement. DO NOT remove
the standard endcap. The endcap will act as the
gasket between the overlay and the shrouding.
3. Assemble U-brackets to corner bracket, using small
screws and nuts (See Figure 3).
4. Attach extension and/or overlay to bracket assembly.
5. Hydropanels w/extensions require 1 Kit each.
TECHNICAL INSTRUCTIONS
HYDROPANEL™ II CORNER MOUNT
SHOWER SYSTEM
A Watts Industries Co.
3-5/16"
[84]
A
C
D
D
B
END CAP
2-1/4"
[57]
'X'
Figure 1. 900 Valve Shown
Figure 2. 410 Valve Shown
Figure 3
B
C
“ X ”
End Cap
Piping Assembly
Corner Mounting
Brackets
Form TI450-CK