Powers 900 Series Biltmore Series Pressure Balancing Mixing Valves - 905 Handle User Manual
Installation instructions
KIT CONTENTS
ITEM
DESCRIPTION
PART NO.
C
ABS Lever Handle . . . . . . . . . . . . . . . .900-091
--
8-32 x 5/8 Handle Screw . . . . . . . . . . .800-164
--
ABS Lever Handle Plug Button . . . . . .900-096
D
Maximum Temperature Limit Stop . . .900-092
(Handle Insert)
TO INSTALL
1. To install dial gasket, peel backing off dial gasket (A) and
attach to inside of dial plate (B). Press fit dial gasket into
groove, leaving gap at bottom for drainage.
2. Attach dial assembly to mixer body with screws as sup-
plied (see Figure 1).
3. Install handle (C) with lever in the downward (six o’clock)
“OFF” position. (Note: Handle is factory preset for maxi-
mum HOT water discharge. When looking inside the han-
dle, dot on temperature limit stop insert (D) is aligned with
dot in molded handle stop (see Figure 2).
MAXIMUM TEMPERATURE SETTING/HANDLE ROTATION STOP
4. Maximum temperature setting adjustment (see Figure 2)
must be set on the job to in no case greater than 46°C
[115°F]. The maximum temperature limit stop (D) is located
in the handle (C). Turn handle counterclockwise to full hot
position. [At full hot position, the maximum temperature
limit stop (D) will rest against the stop (E).]
If the flowing water temperature is below the desired
setpoint: Remove handle and, while looking inside the han-
dle, turn maximum temperature limit stop (D) clockwise.
If the flowing water temperature is above the desired set-
point: Remove handle and, while looking inside the handle,
turn maximum temperature limit stop (D) counterclockwise.
INSTALLATION INSTRUCTIONS
ABS LEVER HANDLE KIT #900-103
For Biltmore 905 Valves
D
C
B
A
ABS
Dial
Plate
900-090
Dial
Gasket
900-094
Dial
Plate
Screws (2)
080-026
Figure 1
H
C
S
T
COLD
WATER
HOT
WATER
Limit Stop D
DOT
on
Limit Stop D
DOT
on
Mixer Handle C
Stop E
SHOWER OUTLET
TUB OUTLET
Figure 2
A Watts Industries Co.
© Reprinted April 2001 Powers, a Watts Industries Co.
3400 Oakton Street, Skokie, IL 60076 Phone: 800.669.5430 • 847.673.6700 • Fax: 847.673.9044
www.powerscontrols.com
5435 North Service Road, Burlington, Ontario, L7L 5H7 Canada • Phone: 888.208.8927 • Fax: 888.882.1979
A Watts Industries Co.
Note: For complete information on Series 900 valve installation, refer to instruction sheet enclosed with valve.
Form
II905-HDL
Form
II905-HDL 0218
EDP# 6507730
Printed in U.S.A.