E-flite F-4 Phantom 32 DF - Manual (Page 9)

9 E-flite F-4 Phantom 32 DF Assembly Manual
Do not use a CA accelerator. Using an accelerator
will not allow the CA to soak into the fibers of
the wood, hardening the hardwood block.
 9. Sand the top of the blocks so they are flush
with the top of the servo. Also trim or sand the
edge of the block so that it does not interfere with
the mounting rim of the wing hole. The blocks may
be a very close fit, and may just hit the mounting
rim on the cover. This is dependant on the exact
location of the servo. Use the screws provided with
the servo and a #1 Phillips screwdriver to attach
the servo to the mounting blocks.
 10. Use a #1 Phillips screwdriver to thread a
2mm x 8mm self-tapping screw into each of the
servo cover mounting holes. This will cut threads
in the surrounding wood. Remove the screw then
apply 2–3 drops of thin CA in each hole to harden
the wood.
 11. Tie the end of the string around the end of the
aileron servo lead. Use the string to pull the leads
through the wing and out at the root rib as shown.
 12. Use four 2mm x 8mm self-tapping screws
and a #1 Phillips screwdriver to secure the aileron
servo cover to the wing.