E-flite Hawker Sea Fury 400 ARF - Manual (Page 23)

23 E-flite Hawker Sea Fury 400 ARF Assembly Manual
Radio Installation - Fuselage
Required Parts
Hook and loop tape Receiver
Y-harness (ailerons)
Servo (two required if using rudder control)
Required Tools and Adhesives
Phillips screwdriver: #0 Pin drill
Drill bit: 1/16-inch (1.5mm)
 1. Mount the rudder and elevator servos in the fuselage
using a pin drill and 1/16-inch (1.5mm) drill bit and the
hardware provided with the servo.
Note: If you have elected not to install the optional
rudder, you will not need to install the rudder servo.
 2. Plug the leads from the servos and speed control to
the appropriate outputs on the receiver. Also connect the
harness for the aileron servo to the receiver.
 3. Use double-sided tape to secure the receiver in the
fuselage as shown.