Watts Autotrol Magnum (CV+ Series) - Manual (Page 62)

58
10.3 Magnum Injector Controls
Note: All flow rates are based on an inlet pressure of 60 psig (413 kPa). Actual rates will vary with pressure,
temperatures and other system variables.
Injector Identification
Tank Size
Part Number
Table 10.2 Magnum Injector Chart
Part Number
Part Number
with O-rings
Tank
Diameter
In. (cm)
Draw Rate
GPM (LPM)
Program P7 Value
1000441 1040670 14 (35.6) 0.5 (1.89) 5
1000442 1040671 16 (40.6) 0.5 (1.89) 5
1000443 1040672 18 (45.7) 0.6 (2.27) 6
1000444 1040673 21 (53.3) 0.9 (3.41) 9
1000445 1040674 24 (61.0) 1.4 (5.30) 14
1000446 1040675 30 (76.2) 2.0 (7.57) 20
1000447 1040676 36 (91.4) 3.3 (12.5) 33
1000448 1040677 Blank 0.0 Filter Application Only