Watts Autotrol Magnum (CV+ Series) - Manual (Page 15)

11
Figure 3.2
Electrical
1. Electrical requirements for the installation will
depend on the configuration of the control.
2. The standard North American Series 962 electronic
control is supplied with a 12 volt wall mount
transformer. Optional wall mount transformers are
available in the following configurations: Japanese
plug @ 100 volts/50 or 60 Hz, Australian/Argentine
plug @ 240 volts/50 Hz, British plug @ 240 volts/50
Hz, European/Italian plug @ 230 volts/50 Hz.
Optional transformers must be ordered separately
for all international 12 VAC configurations.
3. The standard North American Series 952 impulse
controls use 120 VAC or 24 VAC/50 or 60 Hz power.
Lubricants
It is very important that 100% silicone lubricant is the
only lubricant used for installing the Magnum control
valve. Any other lubricant may cause material
degradation and potential failure of the valve
components.
NOTE: Some silicone based lubricants contain
petroleum-based ingredients. If there is a question
about the lubrication that you are using contact the
manufacturer of that lubricant.
Auxiliary Hydraulic
Output Port - Plugged
Pilot Drain Port