Banner SureCross DX80 Wireless Networks - Manual (Page 8)

2 Features
The following feature callouts refer to the DX80 Gateway and Node models, the GatewayPro, and the DX83 Ethernet
Bridge. The wiring diagrams include information for connection power and sensors using the 5-pin Euro-style connect, the
terminal wiring board, and the Industrial Ethernet connection on the DX83 and GatewayPro.
2.1 DX80 Gateway and Node Components
The DX80 Gateway and Node use the same housing and include the same physical features.
1
2
3
4
5
6
7
1. Port, NPT gland, or plug. If unused, install the provided plug
into the 1/2 NPT threaded port. Refer to the Installation
section if an IP67 seal is required.
2. Rotary switch 1 (left). Sets the Network ID (NID) to a
hexidecimal value from 0 to F, for a total of 16 Network IDs. A
Gateway and its corresponding Nodes must be assigned the
same Network ID.
Rotary switch 2 (right). On the Gateway, sets the Gateway’s
LCD viewing device address. The Gateway is predefined as
Device Address 0. On the Node, sets the Node’s Device
Address (hexidecimal 1 to F). Each Node within a network
must have a unique Node Device Address.
3. Push button 1. Single-click to advance across all top-level
DX80 menus. Single-click to move down interactive menus,
once a top-level menu is chosen. Button 1 is also used to wake
integrated battery models from the hibernation mode they ship
in.
4. Push button 2. Double-click to select a menu and to enter
manual scrolling mode. Double-click to move up one level at a
time.
5. LED 1 and 2. Provide real-time feedback to the user regarding RF link status, serial communications activity, and the
error state.
6. LCD Display. Six-character display provides run mode user information and shows enabled I/O point status. This
display allows the user to conduct a Site Survey (RSSI) and modify other DX80 configuration parameters without the use
of a PC or other external software interfaces. On the Node, after 15 minutes of inactivity, the LCD goes blank. Press any
button to refresh the display.
7. 5-Pin M12 Euro-style quick-disconnect serial port
2.2 DX80 Gateway and Node Wiring Chamber
The DX80 Gateway and Node use the same housing and terminal block for wiring.
SureCross Wireless I/O Networks
8