Metrohm 750 Autosampler - Manual (Page 37)

3 Operation
750 Autosampler
34
3.6 Method procedure
RUN/STOP
A previously programmed method can be started by pressing
the key or (as already described in chap. 3.5)
by selection of the menu item " Run Method " in the method
menu. In both cases the following display appears:
Enter Method Number
# N
1 … 10
Select method
Entry of the method number N which is to be started.
After confirmation with the selected
method is started. While the program is running the
following display appears:
METHOD STEP METHTIME
NN MM XXX.X
VIAL INJ RTIME
nnn m xxx.x Status display for running method
While the program is running the following data are
displayed and continually updated:
METHOD
Number NN of current method
STEP Number MM of program step
METHTIME Total elapsed time since method start
VIAL Number nnn of current vial
INJ Number m of current injection
RTIME
Run time of current sample
When the last program step has been completed the
transfer needle is returned to the park position. The
following display appears:
METHOD
COMPLETED
Method completed
The selected method has been correctly completed.
The instrument is ready for a method to be restarted or
to return to the basic condition.
METHOD STOPPED
to Resume
to Abort
to Edit Method stopped
A running program can be stopped at any time with
the key; the transfer needle remains in
its position and the display shown alongside appears.
The three following possibilities now exist:
Continue method run.
Abort method.
Edit the current method, then re-
turn to this selection.