Metrohm 750 Autosampler - Manual (Page 12)

2.1 Setting up the instrument
750 Autosampler
9
2 Installation
2.1 Setting up the instrument
2.1.1 Packaging
The 750 Autosampler is supplied together with the separately packed
accessories in special packagings containing shock-absorbing foam
linings designed to provide excellent protection. The actual instrument
is packed in an evacuated polyethylene bag to prevent the ingress of
dust. Please store all these special packagings as only they can assure
damage-free transport of the instrument.
2.1.2 Check
After receipt, immediately check whether the shipment is complete and
has arrived without damage (compare with delivery note and list of
accessories in section 5.3). In the case of transport damage, see
instructions in section 5.5.1 "Warranty".
2.1.3 Location
Position the instrument in the laboratory at a location convenient for op-
eration, free from vibrations and protected against a corrosive atmos-
phere and contamination by chemicals. The Autosampler should be lo-
cated as close as possible to the IC system to minimize dead volume.
When not in use the instrument should always be covered with the
6.2742.010 dust cover.