Metrohm 864 Robotic Balance Sample Processor - Manual (Page 55)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 3 Installation
864 Robotic Balance Sample Processor ￭￭￭￭￭￭￭￭ 47
Figure 32 Positioning reticle on the sample rack
Defining the adjusting position
Proceed as follows:
1 Prepare
￭ Put the sample rack in place.
￭ Start tiamo ™.
2 Open the configuration
￭ Select the Configuration in tiamo ™.
￭ Double-click the device name 864_1.
￭ Switch over to the Rack tab and click [Rack data] to open the
rack parameter settings.
￭ Select the tab Special beaker.