Metrohm 756 KF Coulometer - Manual (Page 90)

4.2 Remote control commands
756/831 KF Coulometer, Instructions for Use 82
:
Report configuration. If a report line is switched off, the corresponding line will not
be outputted in the reports.
With "Run" on "OFF", only the run number will not be outputted, date (and time) are
available.
4.2.2.53. Config.ComVar.C30
with up to .C39, etc. 0... ± 999 999
Values of the common variables from C30 up to C39. Insert the common variables
directly or describe the determination results directly from the method, see 4.2.2.24.
4.2.2.54. SmplData.Status ON, OFF
On/off switching of silo memory. When the silo memory is switched on, the sample
data are fetched from the lowest valid silo line.
4.2.2.55. SmplData.OFFSilo.Id1 up to 12 ASCII characters
SmplData.OFFSilo.Id2 up to 12 ASCII characters
SmplData.OFFSilo.Id3 up to 12 ASCII characters
SmplData.OFFSilo.ValSmpl 6-digits, sign and decimal point
SmplData.OFFSilo.UnitSmpl up to 5 ASCII characters
SmplData.OFFSilo.Limits read only
Current sample data.
The identifications Id1...Id3 can be used in formulas as sample-specific calculation
constants C21...C23.
If "no unit" is desired for the unit of the sample size, the blank string must be entered.
.Limits: Limits of sample size of current method.
4.2.2.56. SmplData.ONSilo.Counter.MaxLines read only
SmplData.ONSilo.Counter.FirstLine read only
SmplData.ONSilo.Counter.LastLine read only
Information on silo memory.
.MaxLines: Maximum possible number of silo lines.
.FirstLine: Lowest valid silo line.
.LastLine: Last occupied silo line.
4.2.2.57. SmplData.ONSilo.EditLine.1.Method up to 8 ASCII characters
SmplData.ONSilo.EditLine.1.Id1 up to 12 ASCII characters
SmplData.ONSilo.EditLine.1.Id2 up to 12 ASCII characters
SmplData.ONSilo.EditLine.1.Id3 up to 12 ASCII characters
SmplData.ONSilo.EditLine.1.ValSmpl 6-digits, sign and dec.point
SmplData.ONSilo.EditLine.1.UnitSmpl up to 5 ASCII characters
SmplData.ONSilo.EditLine.1.C24 read only
SmplData.ONSilo.EditLine.1.C25 read only
SmplData.ONSilo.EditLine.1.Mark read only
etc., up to .255
Contents of a silo line.