ClearCube R-Series Data Center Products - Manual (Page 78)

54 • Chassis and Blade Installation R-Series Data Center Products User’s Guide
The result should be:
>1
new ip:
4. Type in the desired new IP address. For example:
>1
new ip: 192.168.1.100 (your desired IP address)
The result should be:
RMC Configuration
1. IP address: 192.168.1.100
2. Gateway: 192.168.1.1
3. Network: 192.168.1.0
4. Netmask: 255.255.255.0
5. Password: clearcube
6. Exit
5. Change the Gateway, Network, and Netmask settings, using the same procedure.
For Gateway, use your network’s default gateway setting. For Netmask, use your
network’s subnet mask setting. For Network, use the base network address,
which is typically your subnet mask ANDed with the IP address (also called the
Subnet ID). For example, if your IP address is 192.168.1.154 and your subnet
mask is 255.255.255.0, then if you AND the two addresses together you get a
Network setting of 192.168.1.0.
6. Enter 6 to exit. For example:
>6
The result should be:
>6
Save changes and reboot ?
7. Enter y for yes. For example:
>6
Save changes and reboot ? y
The result should be:
Connection to host lost.
The RMC accepts only a lowercase y as a valid positive response. If you type yes ,
or an upper-case Y , the changes are not saved. Watch for the Saving changes...
message, which confirms the configuration was saved successfully.
NOTE The IP address should be the new one you typed in.
NOTE
You may have to close the telnet window by selecting the X in
the top right corner.