ClearCube Sentral 6.9.3 - Manual (Page 43)

Sentral Quick Start Guide
36 Rev F 2.2.08.06.2014
Figure 22. TightVNC Select Additional Tasks screen
g. The installer starts the TightVNC service and displays the Service Configuration screen.
Specify a password for service authentication and for the control interface or clear the
options to remove password requirements. These passwords apply only to VNC. Click Install.
h. The TightVNC installer shows that installation is complete. Click Next. The Completing
TightVNC Setup Wizard screen is displayed. Click Finish to close the TightVNC wizard.
13. The Sentral Thin Client Agent setup completion screen is displayed. Click Finish to complete Thin
Client Agent installation.
14. Restart the thin client to complete installation. Click Yes to restart immediately or No to
restart later.
15. Optionally, if you moved any data to a network share or other location, move the data back to
the thin client.
16. If applicable, turn on or enable the write filter.
Now that the Thin Client Agent is installed on the device, you can perform a device discovery to
begin managing the host from the Sentral Console.
14.2.2 Linux-Based Operating Systems
The sections below show how to install the Sentral Thin Client Agent on thin clients that run Linux-based
operating systems.
14.2.2.1 Ubuntu ® and Raspbian
The steps below show how to install and uninstall the Thin Client Agent package for Ubuntu and
Raspbian.