Debugging blade discovery, Checklist, Figure 22 – ClearCube Grid Center Admin Guide 4.11 User Manual
Page 42: Getting i/port information
Figure 22 Getting I/Port Information
36 • Configuring Grid Center
Grid Center 4.11 Administrator’s Guide
To see details regarding the I/Port client, click the Get I/Port Client Information link.
The I/Port Client Manager window is displayed (Figure 22) is displayed.
Debugging Blade Discovery
Occasionally, Blade discovery may not seem to work properly. Use this checklist and
set of debugging procedures to isolate and resolve the most common problems.
Checklist
These items should be check to ensure correct Blade discovery:
•
Check the left hand tree to see whether it is in the “collapsed” state. After
performing a discovery, click on the root icon to expand it.
•
Verify that the correct subnet range is specified in the GC configuration.
•
Verify that all the Blades have Grid Center Blade client installed.
•
Verify that the Grid Center installation has not been corrupted by the
ServiceDirectory.xml
file being overwritten. This can happen when older
versions of ClearCube software are installed on a blade after Grid Center. If Grid
Center is the most recent ClearCube software installed, this is not the problem. A