ClearCube Grid Center Admin Guide 4.11 - Manual (Page 13)

Grid Center 4.11 Administrator’s Guide Grid Center Installation • 7
Secondary Console, if desired.
• Administrator logins and passwords for the Consoles, Blades, and I/Ports.
• IP subnet ranges for the Blades and I/Ports.
You should plan your I/Port and Blade groups before installing Grid Center. You can
always create, edit, and delete groups after you configure your network.
On the Blade and Console systems, you need to stop the CC DCI service before
installing or uninstalling Grid Center or its components.
Back up existing Discovery lists if desired. See Migrating Discovery Lists on page 13.
On the Blade and Console systems, check the versions of the JRE, ActiveState Perl,
ClearCube DCI, and Perl PlugIn (if these products are installed), and remove any
previous versions. Installations of Grid Center 4.0 or earlier should also be removed
(see Migrating Grid Center Data on page 13 before uninstalling Grid Center). The
Grid Center installer contains a dialog box reminding you to remove previous
versions. Installations of Grid Center 4.1 should not be removed.
Using Grid Center’s All-in-One Installer
Figure 1 Grid Center All-in-One Installer
The Grid Center 4.11 installation CD provides an All-in-One installer for the
Administration Console that simplifies the task of installation. See Figure 1.
The installer displays all the required components for the Grid Center installation. If a
component needs to be installed, a check box is placed by its name. If it has already
been installed, the box next to its name is empty. The installer then installs each
component selected in the correct order. It is strongly recommended to use the
All-in-One installer to determine the necessary components and their installation
order, and to accept the settings of the installer.