ClearCube C/Port & MVX - Manual (Page 10)

x • Preface
equipment is put into service. Please refer to the installation sections of this manual for
specific power cord requirements. For replacement of power cords, refer to Appendix C –
Technical Support.
• Power Adapters – ClearCube or ClearCube’s Distributors provides power adapters that
are specifically designed for use with that particular piece of equipment and are approved
for use by the local authority having jurisdiction in the country where the equipment is put
into service. Please refer to the installation sections of this manual for specific power cord
requirements. For replacement of power cords, refer to Appendix C – Technical Support.
• IT Power Systems – ClearCube equipment has been evaluated and found to be
compatible with IT power distribution systems with a phase-to-phase voltage not to
exceed 240 V.
• Live Circuits – Operating personnel and service personnel must not remove protective
covers when operating the ClearCube chassis. Adjustments and service to internal
components must be undertaken by qualified service technicians. During any service of
this product other than replacing a PC blade or the fan tray, the main connector to the
premise wiring must be disconnected. Dangerous voltages may be present under certain
conditions. Use extreme caution.
• Explosive Atmosphere – Do not operate the chassis in conditions where flammable gases
are present. Under such conditions this equipment is unsafe and may ignite the gases or
gas fumes.
• Part Replacement – Only service equipment with parts that are exact replacements, both
electrically and mechanically. Contact ClearCube Technology for replacement part
information. Installation of parts that are not direct replacements will void the warranty
and may cause harm to personnel operating the chassis. Furthermore, damage or fire may
occur if replacement parts are unsuitable.
• Modification – Do not modify any part of the C/Port, chassis, or PC blade from its
original condition. Modifications may result in hazards.
• Laser Safety – The Fiber Transceiver and the Fiber C/Port have been evaluated and
certified to an EN 60825-1 – Safety of laser products.
ClearCube Technology products that use lasers display the following graphic on the rating
label:
Marked devices comply with the FDA code of Federal 21 CFR 1040 per Notice 50 and/or the
Canadian Radiation Emitting Devices Act REDR C1370.
CAUTION: Use of controls or adjustments or performance of procedures
other than those specified herein may result in hazardous radiation
exposure.