Brandmotion 1008-6509-V1 - Manual (Page 8)

INSTALLATION INSTRUCTIONS
6509 Instructions 6-18-12 F series (1).doc 8 of 23
Section 4: Chassis Harness Installation continued
24. Center punch and drill a pilot hole then
drill a 1 inch hole with a hole saw.
25. Clean the hole with a deburring tool
(Figure 17).
Figure 17
26. Apply supplied Z-tech with a small brush
(Figure 18).
Figure 18
27. Route the supplied chassis harness
through the drilled opening and seat the
grommet from the inside of vehicle (Figure
19).
Figure 19