Brandmotion 1008-6509-V1 - Manual (Page 10)

INSTALLATION INSTRUCTIONS
6509 Instructions 6-18-12 F series (1).doc 10 of 23
Section 5: Ignition, Reverse and Ground Locations
31. If needed, install aftermarket display or
navigation display per instructions.
32. Remove the passenger side door sill
plate with a trim tool and remove passenger
side kick panel with hands, just disengaging
the two clips from the sheet metal (Figure
24).
Figure 24
33. Route the supplied chassis harness
green, red, and black wires along the vehicle
cross dash harness as shown. Secure using
wire ties wherever possible at 2 inch
intervals.
34. Splice the green reverse wire from the
supplied chassis harness to the wire listed in
Diagram A on page 11 depending on your
vehicle model. Solder and cover the
connection with tape or heat shrink tubing.
35. Attach the black ground wire eyelet
from the supplied chassis harness to sheet
metal in the passenger side kick panel with a
screw using an 8mm socket (Figure 25).
Figure 25
36. Splice the red ignition wire from the
supplied chassis harness to the wire listed in
Diagram A, Page 11. Solder and cover the
connection with tape or heat shrink tubing.
37. Connect the male RCA from the chassis
harness to the camera IN on the aftermarket
display or navigation display. In some cases a
RCA extension may be required.
38. Start the vehicle and shift into reverse.
If all of the connections are correct an image
will appear on the aftermarket display or
navigation display.
39. Reinstall all previously removed interior
and exterior parts.