Brandmotion 1008-6509-V1 - Manual (Page 5)

6509 Instructions 6-18-12 F series (1).doc 5 of 23
Section 2: Cut Pickup Bed Opening
Follow Steps 12 through 16 only if the vehicle does not have an opening in
the bed above the license plate per Figure 6
Figure 6
12. Prepare a clean, flat work surface for
tailgate. Remove tailgate retaining straps.
With an assistant, remove the tailgate by
lifting away from lower tension pins, and set
tailgate aside.
13. Measure 21 inches from the left edge and
1¼ inches from the top and make a
temporary mark on the pickup bed (Figure
7).
Figure 7
14. Center punch the mark and drill a pilot hole.
Next, cut a 1 inch opening with a hole saw
(Figure 8).
Figure 8
15. Clean the rough edges of the opening with a
deburring tool. Apply supplied Z-tech with a
small brush (Figure 9).
Figure 9
16. With the aid of an assistant, reinstall
tailgate on tension pins and reattach straps.