Rockwell Automation 1769-L23E-QB1B_L23E-QBFC1B_L23-QBFC1B CompactLogix Packaged Controllers Quick Start and User Manual - Manual (Page 107)

Publication IASIMP-QS010B-EN-P - October 2009 107
Add a PanelView Plus 600 Terminal Chapter 6
1769-L23 controller
(to complete this step on the 1769-L23E controllers, see
page 105 ;)
IMPORTANT
Before you add the Serial driver in the following steps, you must stop and delete the Serial driver in RSLinx
Classic.
Depending on the messages that display, you might have to take all programming and configuration
software offline. To do so, from the RSLinx Classic File menu, choose Exit and Shutdown.
1. Right-click your
workstation in the
RSLinx Enterprise
browser and choose
Add Driver.
2. Select the Serial DF1 driver
and click OK.
3. Select the Comm Port on
your computer to which
you connected the
1756-CP3 cable.
4. From the Devices
pull-down, select Logix
Platform.
5. Check the Use Auto-configuration
checkbox and click OK.
TIP
If RSLinx Enterprise has been previously configured with a DF1 serial driver, the driver displays in the
RSLinx Enterprise browser.
If the DF1 driver displays in the browser, you do not need to add a serial driver. Skip to step 6 if you do not
need to add the serial driver.