Rockwell Automation 1440-SPD02-01RB XM-220 Dual Speed Module User Manual
Xm-220 dual speed module
Table of contents
Document Outline
- Table of Contents
- Introduction
- Installing the XM-220 Dual Speed Module
- XM Installation Requirements
- Mounting the Terminal Base Unit
- Connecting Wiring for Your Module
- Terminal Block Assignments
- Connecting the Power Supply
- Connecting the Relays
- Connecting the Buffered Outputs
- Connecting the Switched Buffered Output
- Connecting the 4-20mA Outputs
- Connecting the Remote Relay Reset Signal
- Connecting the Startup Switch
- Connecting the Transducer
- Sensor Placement for Reverse Rotation
- PC Serial Port Connection
- DeviceNet Connection
- Mounting the Module
- Module Indicators
- Basic Operations
- Configuration Parameters
- Specifications
- DeviceNet Information
- DeviceNet Objects
- Identity Object (Class ID 01H)
- DeviceNet Object (Class ID 03H)
- Assembly Object (Class ID 04H)
- Connection Object (Class ID 05H)
- Discrete Input Point Object (Class ID 08H)
- Parameter Object (Class ID 0FH)
- Acknowledge Handler Object (Class ID 2BH)
- Alarm Object (Class ID 31DH)
- Device Mode Object (Class ID 320H)
- Relay Object (Class ID 323H)
- Speed Measurement Object (Class ID 325H)
- Tachometer Channel Object (Class ID 326H)
- Transducer Object (Class ID 328H)
- 4-20mA Output Object (Class ID 32AH)
- Glossary
- Index