Rockwell Automation FlexPak 3000 DC Drive Version 4.3 - Manual (Page 93)

Recommended Parts for Integrator Drives C-5
C.2 Wire Control Power to the Drive
Connect the user supplied 115 VAC supply to terminals 188 and 189 of the controller’s
power terminal block. This 115 VAC supply must be rated at 150VA minimum for 150
HP @ 460 VAC and be sized to handle the maximum inrush of the drive FN contactor.
The 189 terminal may be tied to protective earth ground if required. See figure C.3.
Figure C.3 – Integrator Drive Wiring Diagram
SEE SHEETS 3, 8 AND 9
S6/S6R DC ARMATURE SUPPLY
FOR DETAILS.
P5-
6
P5
-5
AC I
N
P
U
T