Rockwell Automation 1756-Enxxx_Ewxxx EtherNet/IP Modules Installation Instructions - Manual (Page 16)

16 Rockwell Automation Publication ENET-IN002F-EN-P - January 2014
Chapter 1 Install a 1756 EtherNet/IP Communication Module
Figure 1 - How Your Module’s IP Address Is Set
If you need to reset your module’s settings to its factory default settings during
normal module operation, see
Reset the Module IP Address to a Factory Default
Value on page 25 .
These tools are used in this sequence to set the network IP address.
1. Set the Network IP Address with the Rotary Switches
2. Set the Network IP Address with the BOOTP/DHCP Server
3. Set the Network IP Address with RSLinx Software or the Studio 5000
Environment
Module Powerup
Module has an IP
address.
Switches set
from
001…254? Yes No
Is DHCP or
BOOTP
enabled?
Yes No
Module requests
address from DHCP/
BOOTP server. Module uses IP address
stored in nonvolatile
memory.