Rockwell Automation 1440-RMA00-04RC XM-440 Master Relay Module - Manual (Page 11)

Rockwell Automation Publication GMSI10-UM009D-EN-P - June 2011
Introduction 11
Organization
To help you navigate through this manual, it is organized in chapters based on
these tasks and topics.
Chapter 1 “Introduction” contains an overview of this manual and the
XM-440 module.
Chapter 2 “Installing the XM-440 Relay Module” describes how to install,
wire, and use the XM-440 module.
Chapter 3 “Configuration Parameters” provides a complete listing and
description of the XM-440 parameters. The parameters can be viewed and
edited using the XM Serial Configuration Utility software and a personal
computer.
Appendix A “Specifications” lists the technical specifications for the XM-440
module.
Appendix B “DeviceNet Information” provides information to help you
configure the XM-440 over a DeviceNet network.
Appendix C “DeviceNet Objects” provides information on the DeviceNet
Objects supported by the XM-440 module.
For definitions of terms used in this Guide, see the Glossary at the end of the
Guide.
Document Conventions
There are several document conventions used in this manual, including the
following:
The XM-440 Relay module is referred to as XM-440, Master Relay module,
device, or module throughout this manual.
TIP
A tip indicates additional information which may be
helpful.
EXAMPLE
This convention presents an example.