Rockwell Automation T6200 Compressor Anti-Surge and Capacity Controller - Manual (Page 77)

HMI-6200 Operator Interface
6-11
Display Layout
Preformatted displays provide the basic operations interface for: compressor/turbine control, continuous
process control, batch/sequence control, SCADA alarms, trends, etc. Information is presented in an
easily understood manner.
The operational displays are organized into a structural hierarchy consisting of overview(s), graphics,
face-plates, etc. Displays are called up through a simple menu bar procedure. In addition to the menus,
the user is provided with “go-to” display buttons to allow for customized window selection.
Besides the configuration at the time the systems is set up, some configuration is normally done later
on, such as building additional graphics.
Analysis of process conditions is fully supported. A standard trend display (real-time and historian
trend), alarm and alert indication (real-time and historical) and diagnostic displays allow for quick
process analysis and situation correction.
Reports and Recipe screens and the ability to retrieve values in XML format facilitate the assessment
and correlation of unit performance.
MICO
NU-200
T6200
Unit Controller
HOME
MICO
NU-200
T6200
Unit Controller
MICO
NU-200
T6200
Unit Controller
MICO
NU-200
T6200
Unit Controller
MICO
NU-200
T6200
Unit Controller
Face-Plates
Graphics
Overview
MICO
NU-200
T6200
Unit Controller
MICO
NU-200
T6200
Unit Controller
MICO
NU-200
T6200
Unit Controller
MICO
NU-200
T6200
Unit Controller
ALARM
ALERT
SUMM
TREN
D
HIST
MICO
NU-200
T6200
Unit Controller
OPER
STATUS
MICO
NU-200
T6200
Unit Controller
MICO
NU-200
T6200
Unit Controller
I-LOCK
ESD
MICO
NU-200
T6200
Unit Controller
MICO
NU-200
T6200
Unit Controller
MICO
NU-200
T6200
Unit Controller
MICO
NU-200
T6200
Unit Controller
LOOP
TUNING
MICO
NU-200
T6200
Unit Controller
MICO
NU-200
T6200
Unit Controller
REPORT
RECIPE
AUX
GRAPHIC
#1 -- #N
Operation/Process Displays Status/Diagnostic/Aux displays
GRAPHIC
#1 GRAPHIC
#2 GRAPHIC
#N
FACE-PL
#1 FACE-PL
#2 FACE-PL
#N
PROC
STATUS
DIAGN
FLOW
CHARTS
DIAGN
FLOW
CHARTS DIAGN
FLOW
CHARTS
The HMI-6200 is designed to facilitate operation at all levels. It allows simplified access to the
controls, provides a logical display format, and incorporates methods for easy interaction with the
process. Operation and management may call up displays from many different unit areas for a concise
picture of unit and plant/pipeline performance.
The HMI-6200 also supports engineering functions in the creation and scheduling of reports and
recipes.
Status displays, diagnostic flow charts, tuning indication and other user-defined auxiliary displays
enable rapid situation correction.
Operational
Display
Hierarchy -
FIGURE 6-8