Rockwell Automation T6200 Compressor Anti-Surge and Capacity Controller - Manual (Page 20)

Input/Output Circuit Description
2-8
Discrete Outputs
The T6200-C Controller can be configured for up to eight discrete outputs. The T6200-D Controller can
be configured for up to 28 discrete outputs. A 100 volt transient absorber is connected on each terminal to
protect the output transistor and to prevent arching between conductors on the circuit board. Each
terminal is protected with a one ampere fuse.
The output transistor in the standby (not ACTIVE) control board is always open.
Discrete output 32 can be used as frequency output, with output frequencies up to 10 kHz. Other discrete
outputs can be used as frequency outputs with output frequencies up to 100 Hz.
Discrete Outputs with Internal Power
In reference to Figure 2-7, a separate internal +24 volt voltage regulator is provided for each output. Each
voltage regulator has thermal, reverse voltage, and short-circuit protection. The regulator can supply 24
Vdc power for a load up to 20 milliamperes continuously and 100 milliamperes momentarily.
Latch
100V
100V
24 VDC
1A
100V
100V
24 VDC
Microprocessor
1A
1A
Termination
Panel
Inhibit from Figure 2-9
Backup Control Board
Primary Control Board
Output from
1A
Voltage
Regulator with
short-circuit
protection
Voltage
Regulator with
short-circuit
protection
Active from Figure 2-9
RS
<20 mA
LOAD
Latch
Microprocessor
Inhibit from Figure 2-9
Output from
Active from Figure 2-9
RS
Discrete
Output with
Internal Power
FIGURE 2-7