Rockwell Automation T6200 Compressor Anti-Surge and Capacity Controller - Manual (Page 47)

Hardware Installation/Maintenance
3-25
Pin Signal
1 TXD+
2 TXD-
3 RXD+
4 +26V PRI
5 +26V SEC
6 RXD-
7 COM
8 COM
Operator Interface Attachment to T6200 Chassis
The Operator Interface is attached to the T6200 Chassis by four screw collars.
The Operator Interface is installed by placing the two top screw collar slots at the rear of the case
over the two top screw collars. The case should be angled slightly out at the bottom. Once the top
screw collars align thru the top screw collar slots, the case can be straightened vertically and then
slide down until it stops on the case slots edge. Refer to Figure 3-23.
The Operator Interface may be removed by pulling the Latch Release Pull located at the bottom right
of the case at the same time sliding the case up then away from the T6200 Chassis.
FIGURE 3-21
Operator Interface
Internal
Ethernet/Power
Cable
Installation
FIGURE 3-22
Operator
Interface J6
Connector Pin
Assignments
Pin 1 Pin 8
FIGURE 3-23
Operator Interface
Attachment to
T6200 Chassis