Side view front view top view regulator board, Rmi board current feedback board rmi board – Rockwell Automation GV3000/SE, VTAC 7 Super Remote Meter Interface Board M/N 2SI3000 M/N 2SI3000E User Manual
Page 20

3-6
Super Remote Meter Interface (RMI) Board
Step 4.
Install the RMI Board in the Keypad Bracket
Refer to figure 3.2 for component locations.
Step 4.1 Remove the RMI board from its anti-static wrapper and verify that the
jumper settings are correct. Refer to figure 2.1 for jumper locations and
appendix A for jumper settings.
Step 4.2 Align the key on the Regulator board’s 34-conductor ribbon cable connector
with the slot in the RMI board’s connector. Press the ribbon cable connector
in until it locks into position.
Step 4.3 Route the 26-conductor ribbon cable for the Current Feedback board out of
the side of the keypad bracket.
Step 4.4 Align the RMI board on the four mounting tabs on the keypad bracket. Make
sure that the ribbon cable is not pinched between the keypad bracket and
the RMI board.
!
ATTENTION: The RMI board contains components that are
static-sensitive. An anti-static wrist band should be worn by any person
who touches the board’s components, connectors, or wiring. Failure to
observe this precaution could result in damage to the RMI board.
Figure 3.2 – RMI Board Location in 1 to 5 HP @ 460 VAC Drives
Side View
Front View
Top View
Regulator
Board
20
16
REV ERSE
AUTO
REM OTE
RUNNING
FORWARD
RPM
Pa ssword
TORQUE
Kw
Hz
JOG
AM PS
VOLTS
PROGRA M
PROGRA M
AUTO
Reverse
JOG
RUN
ENTER
START
RES ET
STOP
Forward
RMI Board
Current Feedback
Board
RMI Board