Rockwell Automation Liqui-Flo Control Configuration Software Version 6.0, M/N 2CS3000 - Manual (Page 73)

Using PC Scope 9-1
C
HAPTER
9
Using PC Scope
This section describes how to use the PC Scope.
9.1 About PC Scope
Use PC Scope to plot drive signals. PC Scope displays the plotted values as a trace.
The type of signals you can acquire depends upon the drive you have connected.
With PC Scope, you can:
• acquire traces of up to two signals at a time
• capture a trace and save it as a snapshot, which you can then compare to a newly
acquired trace
• define a trigger for the traces and specify how much data is gathered and
displayed before the trigger condition
• define a data sampling rate and the number of samples to capture for a given
trace
• define a color for each to help you discern traces and trace snapshots
Figure 9.1 shows the PC Scope screen. The screen has its own toolbar and status
window. Table 9.1 explains the PC Scope toolbar buttons.