Rockwell Automation Liqui-Flo Control Configuration Software Version 6.0, M/N 2CS3000 - Manual (Page 3)

Contents I
C
ONTENTS
Chapter 1 Introduction
1.1 About the Control and Configuration Software ................................................ 1-1
1.2 Software Requirements ................................................................................... 1-1
1.3 Hardware Requirements.................................................................................. 1-2
1.4 Cables ............................................................................................................. 1-2
1.5 Safety Information ........................................................................................... 1-3
1.6 Purpose of This Manual................................................................................... 1-3
1.7 Intended Audience........................................................................................... 1-3
1.8 Terms Used in This Manual............................................................................. 1-4
1.9 Where to Find Additional Information .............................................................. 1-4
Chapter 2 Getting Started
2.1 Before Installing the Software.......................................................................... 2-1
2.2 Installing the CS3000 Software on a Personal Computer ............................... 2-2
2.3 Setting Up Communication Between the CS3000 Software and the Drive ..... 2-3
2.3.1 Connecting the Personal Computer’s Serial Port to the Drive .............. 2-3
2.3.2 Setting Up the Drive to Communicate with the Personal Computer...... 2-5
2.3.3 Selecting the Correct Communication Port ........................................... 2-5
2.4 Starting the Software ....................................................................................... 2-5
2.5 About the Menus and Toolbars ....................................................................... 2-7
2.5.1 About the Menus ................................................................................... 2-7
2.5.2 About the Toolbar.................................................................................. 2-8
2.6 Exiting the CS3000 Software......................................................................... 2-10
Chapter 3 Configuring the Drive
3.1 Selecting a Drive ............................................................................................. 3-1
3.2 Creating a New Configuration ......................................................................... 3-2
3.3 Opening a Drive Configuration File ................................................................. 3-3
3.4 Opening a Configuration File for a Different Version of the Same Drive ......... 3-5
3.5 Editing a Configuration .................................................................................... 3-7
3.5.1 Assigning Parameter Values ................................................................. 3-7
3.5.2 Ending an Editing Session .................................................................... 3-9
3.5.3 Entering and Editing a Configuration Description.................................. 3-9
3.6 Saving a Drive Configuration ......................................................................... 3-10
3.7 Saving the Open Drive Configuration to Another File.................................... 3-11
3.8 Printing a Configuration ................................................................................. 3-12
Chapter 4 Uploading and Downloading Drive Configurations
4.1 Uploading a Drive Configuration...................................................................... 4-1
4.2 Downloading a Configuration to the Drive ....................................................... 4-2
4.3 Comparing the Drive Configuration to the Opened Configuration ................... 4-3
4.4 Comparing the Parameter Values in the Opened Configuration with
Those in Another Configuration File ................................................................ 4-4