Rockwell Automation Liqui-Flo Control Configuration Software Version 6.0, M/N 2CS3000 - Manual (Page 11)

Introduction 1-1
C
HAPTER
1
Introduction
This section describes the computer requirements for the CS3000 software and
presents general information about the software and this manual.
1.1 About the Control and Configuration Software
Use the Control and Configuration (CS3000) software to help you develop drive
configurations on your personal computer for GV3000
,
Liqui-Flo
,
and
FlexPa k

3000 drives. The CS3000 software communicates with the drive through the
personal computer’s RS-232 port.
By using the CS3000 software, you can:
• Create, store, upload, download, and print drive configurations.
• Monitor drive status.
• Monitor and change drive parameters using a personal computer.
• Control the drive (start, stop, etc.).
• Compare a configuration in the drive with one in the personal computer.
• Read and reset the drive fault and error log.
• Create, modify, and store drive configurations.
• Send Memory Save, Memory Restore, and Restore Defaults commands to a
drive.
• Display trace signals in the drive.
1.2 Software Requirements
The CS3000 software requires Microsoft Windows

3.1 or later versions (including
Windows 98 or Windows NT). Make sure Windows is installed and configured on your
personal computer before attempting to install the CS3000 software.