Rockwell Automation 6180 Processor Board (for 6180 Industrial Computers) - Manual (Page 36)

System BIOS Messages C–3
The following table list the error messages that may occur with
devices installed in the PCI card slots.
Message Meaning
Bad PnP Serial ID Checksum The Serial ID checksum of a Plug and Play card was invalid.
Floppy Disk Controller Resource Conflict
The floppy diskette controller has requested a resource that is
already in use.
NVRAM Checksum Error, NVRAM Cleared
The ESCD data was reinitialized because of an NVRAM
checksum error. Try rerunning the ICU.
NVRAM Cleared By Jumper
The Clear CMOS jumper has been moved to the Clear position
and CMS RAM has been cleared.
NVRAM Data Invalid, NVRAM Cleared Invalid entry in ESCD.
Parallel Port Resource Conflict The parallel port has requested a resource that is already in use.
PCI Error Log is Full
This message is displayed when more than 15 PCI conflict errors
are detected. No additional PCI errors can be logged.
PCI I/O Port Conflict Two devices requested the same resource, resulting in a conflict.
PCI IRQ Conflict Two devices requested the same resource, resulting in a conflict.
PCI Memory Conflict Two devices requested the same resource, resulting in a conflict.
Prime Boot Device Not Found
The specified primary boot device (hard disk drive, diskette drive,
or CD-ROM drive) could not be found.
Primary IDE Controller Resource Conflict
The primary IDE controller has requested a resource that is
already in use.
Primary Input Device Not Found
The specified primary input device (keyboard, mouse, or other, if
input is redirected) could not be found.
Secondary IDE Controller Resource Conflict
The secondary IDE controller has requested a resource that is
already in use.
Serial Port 1 Resource Conflict Serial port has requested a resource that is already in use.
Serial Port 2 Resource Conflict Serial port 2 has requested a resource that is already in use.
Static Device Resource Conflict
A non Plug and Play ISA card has requested a resource that is
already in use.
PCI Information and
Error Messages