Rockwell Automation 6180 Processor Board (for 6180 Industrial Computers) - Manual (Page 19)

2–8 Processor Board
4. Lift up on the battery with the tip of your finger and remove
battery.
!
CAUTION: Danger of explosion if lithium battery is
incorrectly replaced. Replace only with the same or
equivalent type recommended by the manufacturer
(220mAh Sony CR2032). Dispose of used batteries
according to the manufacturer’s instructions.
5. Install the new battery with the plus + facing away from the
battery socket as shown on the previous page.
6. Install any removed boards and back panel.
7. You will need to set the system date and time. Refer to Chapter 3
for details on using the BIOS Setup Program.
8. When disposing of the old battery, refer to the battery
manufacturer’s instructions. There may also be additional
disposal regulations in your area.
!
ATTENTION: The battery module contains lithium.
Do not attempt to dispose of it in a fire or incinerator, it
may explode. Always follow regulations in your area
for lithium battery disposal.