Rockwell Automation 6180 Processor Board (for 6180 Industrial Computers) - Manual (Page 22)

3–3 BIOS Setup Program
Main Menu Options Description AB Default Sub Menu Options
Language Language English
Specifies the language used for text strings and help in the Setup
program and the BIOS. The options are:
•
English
•
German
•
Italian
•
French
•
Spanish
Only one language can be resident at one time.
First, Second, Third,
Fourth Boot Device
First: Floppy
Second: Hard Disk
Third: Disabled
Fourth: Disabled
Sets which drives the system checks first to find an operating system to
boot from.
For First Boot Device, the options are: Disabled, Floppy, Hard Disk,
CD-ROM, Network.
For Second, Third, or Fourth Boot Device, the options are: Disabled,
Floppy, Hard Disk, Network.
System Cache Enabled Enables or disables both the primary and secondary cache memory.
Boot Speed Turbo
Sets the system’s boot speed.
•
Deturbo
•
Turbo
If Turbo is selected, boot-up occurs at full speed. If Deturbo is
selected, the board operates at a slower speed.
Num Lock Off
Sets the beginning state of the Num Lock feature on your keyboard.
The options are:
•
On
•
Off
Boot Options
Setup Prompt Enabled
Enables or disables the “Press Key if you want to run Setup”
prompt during powerup. This option does not affect the ability to
access BIOS Setup, it only toggles the prompt.
Boot Options
Hard Disk Pre-Delay Disabled
Sets the hard disk drive pre-delay. Options are 3,6,9,12, or 15 seconds.
A pre-delay causes the BIOS to wait the specified time before
accessing the first hard drive. A pre-delay provides additional time for
a hard drive to initialize.
Typematic Rate
Programming
Default
Sets the typematic rates. The options are:
•
Default
•
Override
Override enables Typematic Rate Delay and Typematic Rate.
Typematic Rate Delay 250
If Typematic Rate Programming is set to Override, this option sets how
long it takes for a key repeat when you hold down a key on the
keyboard. The options are 250, 500, 750, and 1000 millisecond
delays. The default is 250. If the Typematic Rate Programming is set
to Default, this option will not be visible.
Typematic Rate 6
If Typematic Rate Programming is set to Override, this option sets the
speed at which characters repeat. The higher the number, The faster
the characters repeat. The options are 6,8,10,12,20,24, and 30
characters per second. If the Typematic Rate Programming is set to
Default, this option will not be visible.
Scan User Flash Area Disabled Enables or disables scanning of User Flash Area for option ROMs.
Video Mode Displays the video mode (read only).
Mouse Displays if a mouse is installed or not (read only).
Base Memory Displays the amount of base memory (read only).
Extended Memory Displays the amount of extended memory (read only).