Installing your monitor in a rack, Tools needed, Rack mounting guidelines – Rockwell Automation 6185-K Economy Line Monitors User Manual User Manual
Page 13

Installing Your Monitor
13
Publication 6185-UM003C-EN-P
The 6185-K (17” rack mount) is designed for rack mounting, but you can
also install the 6185-J (17” panel mount) into a standard rack.
Using optional rack adapters, you can also install the 6185-H into a rack.
The rack adapter option for the 6185-H is Accessory option R. For rack
adapter installation procedures, see Appendix A: Installing Rack
Brackets on the 6185-H on page 35.
Tools Needed
You will need the following tools:
• EIA panel mounting hardware
• Phillips screwdriver (medium)
Rack Mounting Guidelines
Observe the following precautions when installing this unit in a rack:
• The cabinet must be tall enough to accommodate the monitor's panel
height:
− eight rack units, 14.00" (356 mm), for the 6185-H (15” panel
mount) with adapter
− nine rack units, 15.75" (400 mm), for the 6185-K (17” rack
mount)
• The cabinet must be deep enough to accommodate the monitor's
depth while providing rear clearance for cabling and airflow. The
following cabinet depths are sufficient:
− 2.9" (74 mm) for the 6185-H (15” panel mount)
− 3.0" (76 mm) for the 6185-K (17” rack mount)
• No slides or shelves are required because the rack mount monitor is
designed to be supported by the panels in which it is installed.
Installing Your Monitor in
a Rack