Rockwell Automation 6180 Industrial Computers - Manual (Page 166)

15–6 System Troubleshooting
Publication 6180-6.0
If characters are not displayed on an external monitor:
√
Is the monitor functioning properly?
√
Is the video cable / card properly installed?
√
Check that selected character color is not set the same as the
background color.
√
Is the video board and driver properly installed?
√
Reboot the 6180 Computer.
If the hard drive active LED indicator does not come on:
√
Check the IDE cable connections to the drive.
√
Check the front panel connector on the processor board (refer to the
separate processor board instructions).
√
Check BIOS Setup for proper configuration, is drive enabled?
√
Reboot the 6180 Computer.
If the Power On LED indicator does not come on:
√
Check the front panel connector on the processor board (refer to the
separate processor board instructions).
If the Power On LED flashes:
√
CPU is in a reduced power mode, pressing any key should reactivate
normal operation.
If you can not enter BIOS Setup:
√
Check position BIOS enable jumper. If the jumper enables access to
the Setup program, you may have to clear CMOS RAM to default
values and reconfigure the setup values. Refer to the separate
Processor Board User Manual.