Rockwell Automation 6180 Industrial Computers - Manual (Page 154)

13–32 Keypad Configuration Utility Software
Publication 6180-6.0
The following figure shows how the new feature controls are presented
in the KCU’s Keypad Preferences window (default feature configuration
shown):
Figure 13- 26
If either a non-Alphanumeric keypad configuration or a version of KIC
Alphanumeric firmware older than A5.02 is detected by the KCU, the
Keypad Preferences window will be displayed with the new feature
selection controls grayed out. This is because they don’t apply.
Enabling Single Programmable Key Mode with Abort
If you want to inhibit simultaneous presses of programmable keys and
cause an abort of all key scan code activity if a multi-key sequence does
occur, do the following:
6. Run the Keypad Configuration Utility from the Start>Programs
menu.
7. From the Edit menu, select Keypad Preferences.