Rockwell Automation 8520 9/Series Hardware TAB 5 - Manual (Page 83)

9
8
1
Port A
15
Section 5B
9/440HR CNC/Drive System
5B-9
RS-232 Port (Port A)
Serial port A is used to transmit data to and from peripheral devices. It is
configured for RS-232 communications only. Figure 5B.4 shows this
connector and lists the pin assignments of Port A. For more information
on the signals of each pin, refer to page
8-2.
Figure 5B.4
Port A-J6 (has pin sockets) and Pin Assignments
Pin Assignment
1 Chassis GND
2 Send Data
3 Receive Data
4 Request to Send
5 Clear to send
6 No connection
7 Signal GND
8-15 Not Used
Port B
Serial port B transmits data to and from peripheral devices. Port B can be
configured for either RS-232 or RS-422 communications using the
softkeys on the operator panel (see your 9/Series Operation and
Programming manual). Figure 5B.5 shows this connector and lists the pin
assignments of Port B.
The MTB panel may have the optional serial interface connector mounted
on it. This connector provides an external interface port for RS-232 or
RS-422 interface from a peripheral to the control. It communicates with
ports A or B with cable C07. Refer to the page
7A-22 for additional
information on cable C07. For more information on the signals of each
pin, refer to page
8-7.