Rockwell Automation 8520 9/Series Hardware TAB 5 - Manual (Page 112)

Section 5B
9/440HR CNC/Drive System
5B-38
All external power connections to the 9/440HR CNC/Drive are wired
through the system modules power strip, located behind the front cover in
the lower right corner. Input power is wired to this strip in two different
voltages:
24 V Logic Power – this is 24V ac or 24V dc. The logic power is used
to operate the processors in the system module, axis module logic
boards, and power the encoders.
Drive Power – this is 324-528V ac, three phase, 50/60 Hz. The drive
power is used to supply the drive portion of the 9/440HR the voltages
necessary to power the axis modules and the servo motors.
To this Power
Strip Connector Connect:
W1 +24 V Logic Power
W2 24 V Logic Power common
U, V, W 380/460V ac, three–phase power
(not phase sensitive)
PE System Ground Bar
DC+, INT, COL Shunt resistor connection. When the jumper exists between INT
and COL the internal 200 W shunt is used. When using the
optionally purchased 1000 W shunt the jumper is removed and
the new shunt is installed between DC+ and COL.
All connectors on the power strip support a maximum of AWG 12 gauge solid wire.
5B.5
Power Terminal Block
Connection