Installing computer in panel – Rockwell Automation 6181X-15xxxxxxx VersaView 6181X-IN001B-MU-P User Manual

Page 11

Text mode
Original mode

VersaView 6181H Integrated Display Computers 11

Publication 6181H-IN001B-MU-P

Installing Computer in Panel

To install the computer in a panel using mounting clips:

1. Cut an opening in the panel using the appropriate panel cutout dimensions.

2. Make sure the sealing gasket is properly positioned on the computer. This

gasket forms a compression type seal, do not use sealing compounds.

3. Place the computer in the panel cutout.

4. Install the mounting clips. The mounting clips slide into the slots on the top,

bottom and sides of the computer.

ATTENTION

Disconnect all electrical power from the panel before making
cutout. Make sure the area around the panel cutout is clear. Take
precautions so that metal cuttings do not enter any components
that are already installed in the panel. Failure to follow these
warnings may result in personal injury or damage to the panel
components.