Rockwell Automation 6181 Industrial Computer User Manual
Page 80
9–8
Replacing the Backlight Tubes
Publication 6181-UM001D-EN-P
Removing the flat panel display
1. Remove the 6 screws that
secure the flat panel to the RAC6181 Computer chassis.
Screws securing
flat panel
Retaining screw
Hinged chassis
Flat panel display
2. Remove the retaining screw from just below the top hinge and open
the hinged chassis enough to remove the chassis from the display
assembly. Place the chassis on its side to the right of the display
assembly.
3. Unplug the following connectors:
•
Keyboard connector cable
•
Backlight power/LED cable
•
Touchscreen cable (if applicable)
4. Disconnect the display cable from the flat panel display by removing
the 2 screws holding it to the small printed circuit board on the
display (see figure on the following page). The display assembly is
now completely free of the unit.
Replacing the Backlight
Tubes (12.1 in. Keypad
Version):